25-11-2019
Installation and checking NI LabVIEW and Drivers
26-11-2019
Introduction to DAQ -DAQ System Overview Sensors - signal acquisition - Discussion of signals –Signal Conditioning- DAQ Software - NI LabVIEW - DAQ Hardware -NI MyDAQ - Choosing the measurement system- Numeric data type- -Executing Code Repeatedly Using Loops Use While Loops and For Loops Using Loops with Hardware Application Programming Interfaces (APIs) Executing Code Based on a Condition - Measuring Voltage of Analog signal -Acquiring numeric values Generating an Analog Signal
27-11-2019
Generating and Reading a Digital Signal- Boolean data types- Working with Groups of Data – Arrays Speed Governor Car -door lock system -Automatic Water Dispenser Automatic Tank level monitoring system - Case Structures- Strings - Writing and Reading Data to File Data logging State Machines Design a traffic light controller using S.M- Design of Traffic Signal using Tri Color LED - Working with Filters - Processing of audio signal - Music Equaliser
28-11-2019
NI myDAQ with Soft Front Panel (SFP) Instruments - Function Generator (FGEN)- Oscilloscope (Scope) - Sine Wave Generation-Operational Amplifier -Digital Multimeter (DMM)- Bode Analyzer- Low pass filter -NI Multisim - Low pass filter(simulation) - Operational Amplifier (simulation)- myDAQ Addons- Digital signal processing with EMONAmyDSP- Designing filters from specifications 0to implementation with LabVIEW -Understanding the Connections on the EMONAmyDSP -Setting Up the Experiment
29-11-2019
DAQ Addons – Studying Flight Dynamics With the myVTOL – Background on Vertical Take - Off and Landing rvTOL) – Understanding the Comections on the myvTOL – Setting Up the Experiment - myTemp- Temperature measurement – About the myTemp – Understanding the connections on the myTemp - Setting Up the experiment – Studying Earthquakes with the myQuake – Background on Earthquake Waves – Understanding the Connections on the myQuake – Setting Up the Experiment – Graphical Display EMONA myGLCD – Understanding the Connections on the EMONAmyGLCD – Setting Up the Experiment
30-11-2019
Introduction on MyRIO-MyRIO specifications -Working with the Onboard sensors –Accelerometer- Controlling Onboard LEDs with Onboard Button- Controlling Onboard LEDs with Accelerometer- NI MyRIO Starter REt – Analog input – Peizo Sensor, photocell – Analog output - Buzzer-Digital input-Photo Interrupter- Digital Output - LED - NI MyRI0 Mechatronics kit -Position Control of Continuous & Standard Servomotor – Controlling tank using IR sensor – NI MyRIO Embedded kit – Introduction of Protocol - Displaying the Accelerometer values on LCD -WIFI